Use
this clear overlaminate to provide an extra layer of protection and/or enhance
the gloss of an electrostatically imaged graphic – both indoors and out. It also can be used to laminate selected
Piezo Ink Jet graphics.
When
used with compatible products, produced by one of 3M’s Scotchprint® Graphics
Authorized Manufacturers and applied according to written instructions, this
film can be used to produce a Scotchprint® Graphic.
·
Overlaminate
8908 (ES) produces a luster finish and can be used with most squeeze roll
laminators; no heat is required.
·
This
overlaminate features 3M’s patented e-film technology, offering the following
benefits:
·
minimal
shrinkage, resulting in no edge lifting
·
flexibility
at a wider range of temperatures
·
good
surface conformance
·
excellent
cutting capabilities
Overlaminate
8908 (ES):
·
is
a 2 mil (0.05 mm) transparent, vinyl film; 3 mil (0.08 mm) with the adhesive
·
has
a clear, permanent pressure-sensitive adhesive
·
has
a 78# paper liner
This
film can be used on flat surfaces with or without rivets, simple curved surfaces
and corrugated surfaces. It has a lamination temperature range of 50º to 90ºF
(10º to 32ºC).
Overlaminate
8908 (ES) can be used to laminate:
·
Selected
3M™ Controltac™ Plus Electrostatic
Graphic Films
·
Selected
3M™ Scotchcal™ Graphic Films (ES)
·
3M™
Banner Material RG8450
3M™ MCS™ Warranty
This
product is covered by the 3M™ MCS™ Warranty – the most comprehensive warranty
in the industry.
Additional Product
Information
Overlaminate 8908 (ES) is available in 35.5”, 49” and 53.5” wide by 100-yard long rolls.
This
overlaminate has a shelf life of two years. It should be stored in a clean, dry
area, out of direct sunlight, and at a temperature less than 100ºF (38ºC).
For
more specific product information, please refer to Product Bulletin 8908.